Articles
| Open Access |
https://doi.org/10.37547/pedagogics-crjp-05-01-08
FORMATION OF DESIGN AND TECHNOLOGICAL COMPETENCE OF PUPILS THROUGH THE TRANSFORMATION SYSTEM
Abstract
In this article, the interpretation of transformation in technology lessons, the use of the transformation system in the organization of material processing technology classes, and the introduction of the capabilities of the Gemini CAD program through the transformation system, as well as the use of the transformation system in the formation of design-technological competence in pupils is thought about.
Keywords
Transformation system, Gemini CAD program, Gemini Pattern Editor module
References
O‘zbekiston Respublikasi Prezidentining 2019-yil 29-apreldagi “O‘zbekiston Respublikasi xalq ta’limi tizimini 2030-yilgacha rivojlantirish konsepsiyasini tasdiqlash to‘g‘risida”gi farmoni.
Jurayeva Z.I., Texnologiya fanini o‘qitishda Gemini CADdasturidan foydalanish imkoniyatlari. //Uzluksiz ta’lim. Ilmiy-uslubiy jurnal. Maxsus son. – T.: 2021-y.
Камилова Х .Х., Самухитдинова Л. С., Илхомова М. У., Методические рекомендатсии по ползованию САПР одежди фирми GEMINI CAD. ТИТЛП, Ташкент 2002 г.
Nigmatova F.U, Shomansurova M.Sh., Tikuv buyumlarini loyihalashning avtomatlashtirilgan sistemasi. Darslik. – Toshkent, 2015-y.
Руководство пользователя Gemini Pattern Editor X9-: Venus Technologies Provider. − 2007 г.
Руководство пользователя Gemini Photo Digitizer X9-: Venus Technologies Provider. − 2007 г.
https://cdn.geminicad.com/wp-content/uploads/2016/04/gemini_brochure_x9_russian.pdf
Article Statistics
Downloads
Copyright License
Copyright (c) 2024 Jurayeva Zulayxo Islomovna
This work is licensed under a Creative Commons Attribution 4.0 International License.
Authors retain the copyright of their manuscripts, and all Open Access articles are disseminated under the terms of the Creative Commons Attribution License 4.0 (CC-BY), which licenses unrestricted use, distribution, and reproduction in any medium, provided that the original work is appropriately cited. The use of general descriptive names, trade names, trademarks, and so forth in this publication, even if not specifically identified, does not imply that these names are not protected by the relevant laws and regulations.